Unplug all external devices and perform a hard resetĪ piece of hardware may be interfering with the normal boot process of Windows. If your hard drive is not recognized, click here If you power the computer on and you see a CyberPowerPC logo screen or Motherboard manufacturer's logo screen with a bar at the bottom, and that bar fills up completely and disappears, then your computer has successfully completed POST.Ĭlick Here if Your Computer Does Not Complete POST In many cases, a computer will not attempt to hand off control to the operating system. Verify the computer finishes initial power-up (POST)

Restore the Operating System to Factory Settings.

Unplug all external devices and perform a hard reset.Verify the Computer Finishes Initial Power-Up (POST).No diagnostic codes are present and the power button lights up solid under its normal operating color.An on-screen error message may be present.The hard drive activity light may flicker, stay on or be off.The Caps Lock key is illuminated when toggled.The system powers on has video and proceeds past the CyberPowerPC screen or Motherboard Manufacturer's screen (Screen comes on and goes away, could have the CyberPowerPC, MSI, Gigabyte, ASUS or ASRock Logo) but Windows does not finish booting.Some symptoms of a computer being in a no boot state:

If restore the BIOS to the factory default settings also not be able to enter the system, please use the F3 recovery function to restore the system to the factory state (this method is only suitable for models with MSI factory system).This article describes general troubleshooting of computers that are powering up correctly and passing the CyberPowerPC BIOS screen at boot-up but do not successfully boot to Microsoft Windows 10. Please remove recently installed system updates or drivers/utilities and reboot the system again. When system boot to Startup Settings, please select. When power on the device, please press F3 Hotkey to enter the Windows Recovery Environment and select. After finish the repair process, please press to reboot the system. When system appears, please wait for Windows Automatic Repair.Ģ.

After restarting, check if it can enter the system.ġ. After the following screen appears, press “Enter” to confirm and save the settings.Ĥ. After the following screen appears, press “Enter” to restore the BIOS setting to the factory default.ģ. After entering the BIOS menu, press “F9”. When MSI logo shows up, please keep tapping the “Delete” until you see the BIOS Setup Utility.Ģ. Press the power button to start the notebook. Please follow the steps below to check the BIOS and system setting：ġ.

Windows 10 factory reset from bios